環境工程外文翻譯---通過混凝工藝對貨幣印刷油墨廢水的預處理

1、<p>　　畢業設計外文資料翻譯</p><p>　　附件1：外文資料翻譯譯文</p><p>　　通過混凝工藝對貨幣印刷油墨廢水的預處理</p><p>　　摘 要：使用混凝絮凝工藝去企圖研究來自印度貨幣印刷機油墨廢水的可處理性。對混凝劑,即，硫酸亞鐵、氯化鐵、硫酸鋁和聚合氯化鋁進行研究,然后選擇最合適的混凝劑進行有效的治療,以達到最佳混凝劑濃度。陽離子

2、polyeletrolyte和最有效的促凝劑的結合也是用來進行研究，以評估其影響絮凝沉降性。聚合氯化鋁(PAC)被發現是最高效的混凝劑,可以去除色彩,懸浮物(SS)、生化需氧量和化學需氧量(COD)的95.9 -96.5%,96.5 -97.0%,61.3 -65.8%和54.8 -61.8%,分別在一個最佳濃度的1500 mg / L其他凝聚劑,即是，硫酸亞鐵、氯化鐵和硫酸鋁沒有表現出實質性的色彩褪色,BOD and COD、除了懸浮

3、物與PAC的性能的比較。陽離子ploylectrolyte和PAC在一個最佳濃度的1500 mg / L的PAC和1.0 mg / L的聚電解質的結合進一步提高了研究的各種參數的去除效率,除了改善絮凝沉降速度,減少污泥生成的數量。在絮凝中表現為平均時間速度梯度(G)和混合時間(t)的快速混合強度的效應也被研究了。以一個300 rpm的葉輪轉速(n)和60秒的混</p><p>　　關鍵詞:混凝劑、混凝、貨幣出版社

4、、絮凝,凹版印刷、混合時間、油墨廢水、沉降、速度梯度、廢水處理</p><p><b>　　1．前言</b></p><p>　　干膠印和凹印過程是在印度被用于貨幣印刷。雕刻的墨可能是干燥油型或溶劑的類型，它們是用一個合適的溶劑與樹脂制成的。溶劑油墨是由溶解樹脂制造的,即，硝基、馬來樹脂、醋酸乙烯樹脂、天然瀝青,或天然樹脂,也就是，二甲苯,甲苯,高沸點的礦物稀釋劑。通

5、常, 使用的油墨相當僵硬的，它能在紙上位于合適的位置。通常,印刷的油墨是一個復雜的、多成分的組合，主要是由染料和顏料、樹脂、粘合劑、溶劑和可選的添加劑組成的。顯然, 印刷過程產生的廢水是高度有色的,且受到有機礦物質的污染，由于之前提到的化合物。因此, 來自于這樣的印刷設備的廢水不能直接排入接收的溪流或未經任何處理的土地,這不僅由于其有害影響人類健康和環境,也因于在美感上，顏色的可見度，甚至在低集中時。</p><p&

6、gt;　　文獻沒有提供很多關于從凹版印刷過程中產生的廢水的特點的參考資料,也沒有提供其處理方法。然而,最常見的對從各種廢水中的色彩和有機物質去除(BOD和COD)的預處理，從主要包括物理化學方法, 吸附和先進的化學氧化過程。然而,吸附和先進的氧化過程并不是作為預處理選擇的技術和經濟可行的,它更適合作為三級處理被采用。物化處理是在處理廢水作為一個基本的步驟。然而, 作為一個完整的處理系統，它的廣泛使用，與生物治療相比是有限的,主要是由于處

7、理和搬運大量因?yàn)榛瘜W(xué)混凝劑的添加而產生的污泥。</p><p>　　因此,本研究主要針對,通過混凝絮凝過程印刷鈔票產生的油墨廢水的預處理。不同濃度的不同混凝劑對絮凝研究的影響是通過大量的懸浮物體分離試驗來確定的，最有效的凝結劑及其最佳濃度的確定是從色彩，SS和有機接頭的立場(BOD和COD)刪除處理。此外,助凝劑的影響在沉降的絮體也有記錄。實驗室研究進一步進行了絮凝模型與渦輪葉輪的快速混合，其次是緩慢的攪拌和混合

8、絮凝沉降調查效果，沉降速度上的絮狀物顆粒在文檔中也有標記。</p><p><b>　　4. 結論</b></p><p>　　基于混凝過程的詳細實驗，已經證明這種處理模式是一個適當?shù)念A(yù)處理選項，如處理貨幣印刷機中的油墨廢水。它提供高效的色度去除清液。此外，由于其具有性能穩定，可以很好的去除有機物BOD和COD，因此它的懸浮物去除率也很高。</p>&l

9、t;p>　　在混凝劑試驗,PAC將作為最有效的絮凝劑。陽離子聚電解質與PAC結合，加強了污泥絮體分離從而增加了沉降速度，于是進一步提高了處理的效率?；炷齽┑淖罴褲舛葴y(cè)定是通過以消耗最少混凝劑達到最高的加工效率而劃定的。</p><p>　　影響迅速混合的最佳GT值的測定是通過絮狀沉淀研究來評估的。研究表明，緩慢混合多久都不能提高系統的性能，而流程效率上的顯著效果是通過初期的快速混合達到的。</p>

10、;<p>　　因此，混凝的處理模式，絕對可以作為一個兼容的高強度彩色印刷機的油墨廢水預處理選項。</p><p><b>　　附件2：外文原文</b></p><p>　　PRE-TREATMENT OF CURRENCY PRINTING INK WASTE WAT- ER THROUGH COAGULATION- FLOCCU LATION PROC

11、ESS</p><p>　　TAPAS NANDY?, SUNITA SHASTRY, P. P. PATHE and S. N. KAUL</p><p>　　National Environmental Engineering Research Institute, Nehru Marg, Nagpur, India</p><p>　　(Received 27

12、 March 2002; accepted 1 April 2003)</p><p>　　Abstract：Attempt has been made to study the treatability of printing ink wastewater generatedfrom an Indian currency printing press using coagulation-?occulation

13、process. Coagulant agents,viz. ferrous sulphate, ferric chloride, aluminium sulphate and polyaluminium chloride were studied to select the most suitable coagulant for effective treatment, and attain the optimum coagulant

14、 concentration. Cationic polyeletrolyte in conjunction with the most effective coagulant was also studied to assess it</p><p>　　Keywords: coagulants, coagulation, currency press, ?occulation, intaglio printi

15、ng, mixing time,printing ink wastewater, sedimentation, velocity gradient, wastewater treatment</p><p>　　1. Introduction</p><p>　　Dry offset and intaglio printing processes are adopted for curr

16、ency printing in India.The inks for engraving may be of drying oil type or of solvent type formulated with a resin and suitable solvents. Solvent inks are made by dissolving resins,viz. nitrocellulose, maleic resins,viny

17、l acetate resin, gilsonite, or natural resins insolvents, viz. xylol, toluol, and high-boiling mineral thinners. Generally, the inks used are quite stiff enabling to hold in place on the paper.Typically, printing ink <

18、;/p><p>　　The literature did not provide much reference on the characteristics of wastewater generated from intaglio printing process, and its treatment. However, the most common pre-treatment for colour and or

19、ganic substances removal (BOD and COD)from various wastewaters mainly comprises of physico-chemical methods, adsorp-tion and advanced chemical oxidation processes .However, adsorption and advanced oxidation processes are

20、 not techno-economically viable as pre-treatment option, and are more appropriat</p><p>　　Therefore, this study basically aimed at, pre-treatment of printing ink wastewater generated from printing of currenc

21、y notes through coagulation-?occulation process. The effect of various concentrations of different coagulant agents on ?occulation investigated through extensive jar test studies to determine the most ef?cientcoagulant,

22、and its optimum concentration in terms of colour, SS and organic sub-stances (BOD and COD) removal are addressed. In addition, effect of coagulantaid on settling o</p><p>　　4. Conclusions</p><p&g

23、t;　　Based on detailed experimentation on coagulation-?occulation process, this mode</p><p>　　of treatment has proved to be an appropriate pre-treatment option for printing ink wastewater such as from currenc

24、y printing press. It provides ef?cient colour removal producing clear supernatant. Moreover, suspended solids removal is also very high with stable performance achieved for removal of organic substances in terms of BOD a

25、nd COD.</p><p>　　Among the coagulants experimented, PAC performed as the most ef?cient ?occulating agent. Use of cationic polyelectrolyte in conjunction with PAC further improved the treatment ef?ciency resu

26、lting from increased ?oc separation through enhanced sludge settling velocity. Determination of optimum concentration of coagulant agents has been delineated to achieve maximum process ef?ciency with</p><p>

27、　　minimum consumption of coagulant agents.</p><p>　　Effect of rapid mixing as evaluated through ?oc settling studies led to the determination of an optimum Gt value. Studies reveal that slow mixing provided

28、for more than few minutes does not improve the system performance indicating that the signi?cant effect on process ef?ciency is through initial rapid mixing.</p><p>　　Thus, coagulation-?occulation mode of tr