無線局域網外文翻譯

1、<p><b>　　Abstract</b></p><p>　　This paper focuses on the development of an energy efficent street lighting remote management system making use of low-rate wireless personal area networks and

2、 the Digital Addressable Lighting Interface (DALI) protocol to get a duplex communication, necessary for checking lamp parameters like lamp status, current level ,etc.Because of the fact that two thirds of the installed

3、street lighting systems use old and inefficient technologies there exists a huge potential to renew the street lighting a</p><p>　　Introduction</p><p>　　Two thirds of the current installed stree

4、t lighting systems still use very old and inefficient technologies, that is , there exists a huge potential to renew the existing street lighting and save in the energy consumption[1]. It is estimated that nearly the 5%

5、of the energy used in lighting applications is consumed by the street lighting, being the most important energy regarding the energy usage in a city . New industrial approaches have been develop recently in order to achi

6、eve an efficient li</p><p>　　Saving energy in street lighting can be achieved with two methods,by controlling the light duration or by dimming. There also exist remote management systems that allow the user

7、to keep an individual remote control and monitorization of every single lamp. By making use of these systems the operator can monitor the main parameters of any light point from a central or mobile unit. The obtained dat

8、a are ready for processing, allowing the reckoning of statistical consumption, lamp status, voltages, </p><p>　　In order to have an optimum control, the remote management system should allow a duplex or half

9、/duplex communication between the user and the ballast; otherwise we could not know the lighting status. The management system is implemented using a communication system and a lighting control protocol. The communicatio

10、n system can be wired,such as Ethernet, optical fiber and Power Line Carrier(PLC) or wireless. Among the last group we have GSM/GPRS, RF,WiFi,WiMAX,IEEE802.15.4 and ZigBee have brought </p><p>　　A WSN consis

11、ts of tiny sensor nodes, sink nodes, an information transport network and personal computers. Usually, WSN architecture consists of three layers, the physical layer, the MAC layer and the application layer. The IEEE802.1

12、5.4 standard deals with Low-Rate Wireless Personal Area Networks(LR-WPAN); its aim is to standardize the two lower layers of OSI protocol stack, i.e.physical layer and medium access control layer. It only considers star

13、and peer-to-peer network topologies. On the othe</p><p>　　As regards the lighting control protocol, it can be chosen between an open protocol,like TCP/IP , BACNet, DMX512,LONWorks,X-10, 0-10 V or DALI, or pr

14、oprietary.DALI stands for Digital Addressable Lighting Interface, it was defined by annex E.4 of IEC 60929 as a digital signal controller for tubular fluorescent lamp ballasts' control interface and modified by IEC 6

15、2386, which also integrates other application of DALI apart from lighting and extends the kind of lamp to high intensity discharge (HID</p><p>　　This paper focuses on developing a street lighting management

16、system by making use of wireless sensor networks and DALI ballasts, materials used in the system are described and results about tests and measurements are presented.</p><p>　　Background</p><p>

17、　　Several scientific researches have been carried out in order to take the WSN advantages to the street lighting systems. For example, reference[4] explains the development of a wireless control system based on ZigBee. T

18、heir system allows the user to control and monitor the state of the lighting , but they do not focus on the energy efficienty, just the maintenance and the removal of wires in public areas for the people safety. Referenc

19、e[5] gives a more complex exemple of WSN applied to street lig</p><p><b>　　文摘</b></p><p>　　這一張主要是關注基于無線節能局域網和DALI協議的節能型路燈的遠程控制系統之間的連接，用于檢查單個路燈，比如路燈的位置、路燈的電流等。因為2/3的路燈都是用的老式低效的安裝系統所以重

20、新安裝這里面潛在著巨大的節能價值。這個基于DALI協議的路燈控制系統的提議在最大程度上增加了設備（鎮流器）不過能被原始DALI控制的鎮流器最多只有64個。有些意見認為路燈控制協議和通信系統還需討論，需要從實驗得到幾個測試結果。</p><p><b>　　介紹</b></p><p>　　2/3路燈的電流安裝系統仍然用的是老式低效率技術，這就是說，重新安裝來減少能源浪

21、費存在著巨大的潛在價值。據估計只有5%的能源應用于路燈的照明，認為是成為城市最為重要能源用途。最近為了有效率的照明新的工藝方法真在發展，可以總結為燈的技術和電子鎮流器的改進、軟件控制開關、無噪聲性能和照明控制。</p><p>　　路燈的節能可以通過兩種方法達成，控制照明時間和昏暗度。同樣存在這樣的遠程控制系統允許使用者對每個單獨路燈的控制和檢測。使用這種系統的話經營者可以監測到任何中央或是移動單元的照明點的主要

22、參數。獲得的參數馬上可以處理，可以估算統計消耗、燈的位置、電壓、異常等，減少維修時間。另外一個有趣的參數是弧電壓的水平，（這個。。。。。），減少維護經費。</p><p>　　為了得到最佳控制，這種遠程控制系統應該允許運用者和鎮流器之間可以雙工或者辦雙工工作；不然我們就不知道照明的位置。這個控制系統的實施要用到一個通信系統和一個照明控制協議。通信系統可以是有線的，比如以太網、光釬、PLC或者是無線無的。我們已有的

23、GSM/GPRS、RF、WiFi、IEEE802.15.4和ZigBee給我們在無線傳感方面帶來了巨大的繁榮。關于無線傳感的綜合學習標準可以在注解2和3中找到。</p><p>　　無線傳感網絡由微小的傳感器節點、匯點，傳輸網絡和個人計算機組成。通常，無線傳感網的筑建是由三層的，物理層、MAC層、應用層。IEEE802.15.4和低頻無線局域網一起；它的目的是為了規范下面兩層OSI協議堆棧，在物理層通過介質訪問控

24、制層。它被認為是星型和單對單的網絡拓?fù)?。另一方面，ZigBee定義了上面兩層，即網絡層和應用層，它的主要貢獻是為IEEE802.15.4提供形成集成、樹形和網格。</p><p>　　這個照明控制協議，可以在開放協議像TCP/IP、BACNet、DMX512、x-10、0-10v、DALI或?qū)Ｓ兄羞x擇。DALI是數字可尋址照明界面，它是由IEC 60929的E.4定義成作為管狀熒光燈控制界面的數字信號控制器并由I

25、EC 62386改性，也集成了DALI的其他功能除了照明和延伸到高強度排放燈（HID)、鹵素?zé)?、白熾燈、LED燈等。</p><p>　　這一張主要是關于無線接入網和DALI鎮流器在路燈控制系統上的發展，在這個系統上運用何種材料在被描述著以及測試和測量也已提出。</p><p><b>　　背景</b></p><p>　　幾項科學研究的提出是

26、為了將無線傳感的好處用于路燈系統。比如，參考【4】解釋的ZigBee的無線控制系統。他們的系統允許用戶控制和監控照明的狀態，但他們并未關注能源的效率利用問題，只是維護和在公共地帶去除電線以保護人的安全。參考【5】給出了一個更復雜的關于無線傳感用于路燈的例子，他們的系統是由傳感器節點安在每個路燈桿再一個匯點安在變壓器上（可以控制每個路燈桿上節點）組成的。每一個匯點上的信息由GPRS送到控制中心。這個系統（。。。）逐漸增強到60%同樣是為了